Some people prefer wood over vinyl siding for many reasons. Wood siding, for example, can be less expensive than vinyl siding. Wood siding is another form of exterior finish that can make your property seem more appealing. It's also simple to set up. Apart from wood and vinyl siding, there are a variety of other siding choices to choose from. Aluminum, clapboard. If you wish to install wood siding on your house or commercial building, there are a few different types of wood that building professionals recommend. Unfinished red cedar and cypress are just two common examples.

The wood siding must be in the form of horizontal overlapping boards for a successful installation. They should have a width ranging from 4 to 12 inches, and the overlaps should range from ½ to 2 inches in length. There are many horizontal joints that allow you to fasten yourself to the wall frame. We serve as your favourite siding contractors in Vancouver.

Step 1 - Gather supplies, equipment, and materials for the siding installation

Before you start installing wood siding, you'll need to apply a layer of plywood sheathing to the surface. On the outside surface of the wood frame of the house, you'll also need to install felt building paper. The felt paper would serve as both a water and air barrier. It will also allow water to pass through and aid

Step 2 – Cutting Wood Siding Materials

This is best accomplished with a circular saw. It will enable you to cut the boards to the required length. The circular saw can assist you in ensuring that each connection ends on a stud. You should take measurements using a measuring square if you don't want uneven gaps between the wood boards after they're cut into their appropriate squares. If you do not. Make sure you cut slowly to avoid splintered or jagged edges. Install the siding such that the joints can align vertically in the alternating courses if possible.

Step 3 – Installing Your Wood Siding

In the third step, you must keep in mind that the siding must be put on from the bottom up. It's also important to scaffold it to complete the structure. To install the lowest siding board, adhere it to the plywood sheathing at the bottom. Ensure that it protrudes at least an inch below the foundation's wall.

Step 4 – Border and Edge Treatments

When you're finished, the lower siding board must be removed to allow it to fit against the soffit. The ripped edge of the torn piece must be covered with a frieze board. A frieze board is nailed through your wood siding and sheathing at a slant. At the point where the wall meets the rake. Take the length measurements of the bottom edge of the board to a long point. You should also take along the top edge until it reaches a short point. Before you install the wood siding, make sure the vertical corner boards are in place. When attaching the siding to the door and window, use similar caution.

It's also critical that you follow the necessary safety precautions when performing this installation. Get the safety goggles for any new materials to protect your eyes. To safeguard your feet, wear safety boots. It is also suggested that you don't do this job if you have a history of heart attacks or stroke. Wear rubber gloves when working with nails to prevent injuries.

If you're interested in getting siding installed in Vancouver for your new construction project or building renovation, get in touch with our team today!